Representatives
Rep Portal
Mood lightingOur furniture LED extrusions easily fit into a drawer, cupboard or narrow niche. Extrusions with a smooth, round cross-section can become the basis for the construction of an elegant lamp. The kitchen, bathrooms and bedrooms illuminated with a warm glow will make us feel absolutely special in our own house. Extrusion used PDS-O.
pic. 1
Some special accessories can make one of the typical KLUŚ extrusions radically change its function. After adding the base with the power supply, the PDS-O round LED extrusion turns into a minimalist free-standing lamp.
pic. 2
Some special accessories can make one of the typical KLUŚ extrusions radically change its function. After adding the base with the power supply, the PDS-O round LED extrusion turns into a minimalist free-standing lamp.
pic. 3
An atmospheric mood at home can be created by backlighting transparent or matte glass shelves. The PULA extrusion, designed specifically for this, ensures solid mounting and backlight. It adapts to the thickness of the shelf and provides independent, double illumination of the edge and the plane.
pic. 4
Decorative lighting does not have to be bright and it should not illuminate too large of a surface. The original proposal of KLUŚ is the LIT-L concealed LED extrusion. This extrusion, after concealing under a layer of plaster, creates an arched niche, from which a subdued LED light eminates. This is a proposal of a very effective finish of the wall instead of a cove.
pic. 5
The MICRO-K recessed LED extrusion is used for subtle lighting of shelves, drawers, cabinets. The extrusion is mounted in a previously prepared groove where its wide flange can cover the unsightly cut edges of the groove.
pic. 6
One of the most interesting accessories in the KLUŚ offer is conductive end caps. They are used for suspending extrusions, e.g. PDS-O on steel wires or rods and conducting electricity so no additional power wire is necessary.
pic. 7
One of the most interesting accessories in the KLUŚ offer is conductive end caps. They are used for suspending extrusions, e.g. PDS-O on steel wires or rods and conducting electricity so no additional power wire is necessary.
pic. 8
One of the most interesting accessories in the KLUŚ offer is conductive end caps. They are used for suspending extrusions, e.g. PDS-O on steel wires or rods and conducting electricity so no additional power wire is necessary.
pic. 9
